Network Setup - D-Link DCS-932L User Manual

Section 3 - Configuration
This section allows you to configure your network settings.
DHCP: Select this connection if you have a DHCP server running
on your network and would like a dynamic IP address to be
updated to your camera automatically.
You may obtain a static or fixed IP address and other network
Static IP Client:
information from your network administrator for your camera. A
static IP address will ease you for accessing your camera in the
future.
IP Address: The fixed IP address
Subnet Mask: The default value is "255.255.255.0." Used to
determine if the destination is the same subnet.
Default Gateway: The gateway used to forward frames to
destinations in a different subnet. Invalid gateway settings may
cause the failure of transmissions to a different subnet.
Primary DNS: Primary domain name server that translates names to IP addresses.
Secondary DNS: Secondary domain name server to backup the Primary DNS.
PPPoE Settings:
If you are using a PPPoE connection, enable it and enter the User Name and Password for your PPPoE account. You can get
this information from your Internet service provider (ISP).
Port Settings:
You may configure a Second HTTP port that will allow you to connect to the camera via a standard web browser. The port can be
set to a number other than the default TCP ports 80. A corresponding port must be opened on the router. For example, if the port
is changed to 1010, users must type "http://192.168.0.100:1010" instead of only "http://192.168.0.100".
UPnP Settings:
Enable this setting to configure your camera as an UPnP device in the network.
D-Link DCS-932 User Manual

Network Setup

18