Table of Contents
Advertisement
Step 12. Note the orientation of the new microprocessor. Hold the new microprocessor by its edges and
align the notches
new microprocessor straight down into the microprocessor socket.
Note: The small triangle
indicator. The new microprocessor is in the correct orientation when this indicator points to the beveled
4
corner
of the microprocessor socket.
Step 13. Close the microprocessor retainer and lock it into position with the small handle to secure the
new microprocessor in the socket.
Step 14. Reinstall the heat sink and fan assembly.
Step 15. Pivot the drive bay assembly downward.
Step 16. Reinstall all the removed parts, and then reconnect the cables.
Replacing the front fan
To replace the front fan: (Selected medels only)
Step 1.
Remove any media from the drives, shut down the operating system, and turn off the computer
and all attached devices.
Step 2.
Unplug all power cords from electrical outlets.
Step 3.
Disconnect all cables attached to the computer. This includes power cords, input/output (I/O)
cables, and any other cables that are connected to the computer. Refer to Locating connectors,
controls and components to locate the various connectors.
Step 4.
Remove the computer cover. Refer to Removing the computer cover.
Step 5.
Remove the front bezel. Refer to Removing the front bezel.
Step 6.
Pivot the drive bay assembly upward.
1
on it with the tabs
2
3
on one corner of the new microprocessor is the microprocessor orientation
in the microprocessor socket. Then, carefully lower the
.
Chapter 8
Replacing hardware
47
Hide quick links:
Advertisement
Table of Contents
