Needle Stop Position Setting; Auto-Off Timer - Janome Sewist 740DC Instruction Book

z
q
x
c
z
q
x
r
c
w
e
r
w
e
t
e
y
25

Needle stop position setting

You can set the needle stop position to up or down when
the machine stops.
Enter the setting mode.
Press the " " of the arrow key q.
The default setting is up and "UP" mark is blinking.
z To set the needle stop position to the down position,
press "+" of the stitch length adjusting key w, and the
"dn" mark will blink.
x To set the needle stop position to the up position,
press "+" of the stitch width adjusting key e, and the
"UP" mark will blink.
c Press the START/STOP button r to apply the setting.

Auto-off timer

NOTE:
The auto-off timer is available in EU countries and
some regions which use 200 - 240 voltage standards.
The machine will be turned off if you do not use the
machine within the time period set by this timer.
Enter the setting mode.
Press " " of the arrow key q twice.
The setting screen "Auto-off timer" appears.
The default auto-off timer setting is 7 hours and "07" sign
w appears on the screen.
z Press "+" of the stitch length adjusting key e to
increase the setting value.
Press "+" of the stitch width adjusting key r to
decrease the setting value.
The auto-off timer can be set from 1 to 12 hours.
x If you wish to turn off the timer, press and hold the "+"
of stitch length adjusting key e or stitch width adjusting
key until "oFF" mark t appears on the screen.
c Press the start/stop button y to apply the setting.