Advertisement
OPERATING INSTRUCTIONS
WARNING: THIS UNIT IS INTENDED TO BE USED WITH
COLD WATER ONLY! DO NOT USE HOT WATER IN THIS
PRESSURE CLEANER!
STARTING AND STOPPING YOUR PRESSURE CLEANER
Never switch your pressure cleaner ON unless the water has
been turned on and connected to the pressure cleaner first.
Your pressure cleaner is equipped with an automatic on/off
switch. The pressure cleaner will only run when the power
switch is in the ON position and the trigger on the gun is
squeezed, with water flowing through. When you release the
trigger to stop spraying water through the gun, the motor will
automatically shut off. Simply squeeze the trigger again to
resume using the cleaner. Always ensure that you plug your
pressure cleaner into a standard 240V AC power point.
OPERATING SWITCH
To turn your pressure cleaner ON, rotate the switch to 'ON/l'.
To turn your pressure cleaner OFF, push the switch to'OFF/0'.
GUN SAFETY LOCK (PIC. 6)
This pressure cleaner is equipped with a gun trigger safety lock.
When not using the pressure cleaner, use the safety lock to
keep from accidentally engaging the high pressure spray.
BLEEDING THE PRESSURE WASHER SYSTEM
It is very important to bleed the gun before using the
pressure cleaner.
To bleed the gun, simply connect the garden hose to the
pressure cleaner and squeeze the trigger BEFORE turning the
electrical supply on. This allows any air trapped inside the
pressure cleaner and gun to be removed before using the unit.
Continue holding trigger for approximately one minute to allow
any excess air out of the unit. Water will flow through the gun
at low pressure during this procedure.
TO START USING
1. Ensure your pressure washer is fully assembled, including
the lance and nozzle.
2. Ensure the high pressure hose is firmly connected to the
units outlet.
3. Connect your water hose to the pressure cleaner inlet.
4. Connect your water hose to the mains tap and turn on.
5. Un-lock the safety gun lock.
6. Bleed the pressure washer system.
7. Connect your pressure cleaner to a 240V AC power outlet
and turn on.
8. Switch pressure cleaner ON.
9. Pick up gun, point at object to be cleaned and
squeeze trigger.
NOTE: The unit should be turned completely OFF while not
in use or while unattended.
GUN ROTATION PIC, 7
To ensure user comfort and ideal cleaning angle this model
allows for the gun to rotate independent of the fitted nozzle.
To rotate the gun;
1. Release trigger to stop water flow.
2. Rotate the nozzle to the desired position.
3. Squeeze trigger to start using pressure washer again.
PIC. 7
12
PIC. 6
Advertisement
