Points In Operation And How To Stop - Makita EM2510LH Instruction Manual

Nylon cutting head operation
The nylon cutting head is a dual string trimmer head provided with a bump &
feed mechanism.
To cause the nylon cord to feed out, tap the cutting head against the ground
while rotating.
The most effective cutting area is shown by the shaded area.
NOTE:
If the nylon cord does not feed out while tapping the head, rewind/replace the
nylon cord by following the procedures described under "Maintenance".

POINTS IN OPERATION AND HOW TO STOP

CAUTION:
Hold the machine firmly when starting the engine. Otherwise falling machine may result in personal injury.
Observe the applicable accident prevention regulations!
Starting
Move at least 3 m away from the place of refuelling. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool
does not come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to operation position.
3) Close the choke lever.
Choke opening:
– Full closing in cold or when the engine is cold.
– Full or half opening in restart just after stop of operation.
4) Primer pump
Continue to push the primer pump until fuel enters into the primer pump. (In
general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
1
Carburetor
Primer Pump
17
CLOSE