Points In Operation And How To Stop - Makita EM2653LH Instruction Manual

Nylon cutting head operation
The nylon cutting head is a dual string trimmer head provided with a bump &
feed mechanism.
To cause the nylon cord to feed out, tap the cutting head against the ground
while rotating.
The most effective cutting area is shown by the shaded area.
NOTE:
If the nylon cord does not feed out while tapping the head, rewind/replace the
nylon cord by following the procedures described under "Maintenance".

POINTS IN OPERATION AND HOW TO STOP

CAUTION:
Hold the machine firmly when starting the engine. Otherwise falling machine may result in personal injury.
Observe the applicable accident prevention regulations!
Starting
Move at least 3 m away from the place of refuelling. Place the Petrol Brushcutter on a clean piece of ground taking care that the cutting tool
does not come into contact with the ground or any other objects.
A: Cold start
1) Set this machine on a flat space.
2) Set the I-O switch (1) to operation position.
3) Primer pump
Continue to push the primer pump until fuel enters into the primer pump (1).
(In general, fuel enters into the primer pump by 7 to 10 pushes.)
If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
4) Recoil starter
Pull the start knob gently until it is hard to pull (compression point). Then,
return the start knob, and pull it strongly.
Never pull the rope to the full. Once the start knob is pulled, never release
your hand immediately. Hold the start knob until it returns to its original
point.
5) Warm-up operation
Continue warm-up operation for 2 to 3 minutes.
1
(1)
16