Table of Contents
Advertisement
CDD
USER GUIDE
Second fix:
With ceiling mounting, the cabinet will probably be used in landscape mode. Fit the cabinet
section of the wall bracket (previously removed from the arm). The bracket is attached orientated
as shown by removing four screws with an M4 hex key and attaching the bracket with the same
screws. In the case of the CDD6, there are only four fixing points; the CDD8 has six: use the four
"upper" ones. The photo below illustrates the fixings on a CDD6:
Note that is vital that the driver is orientated to suit the deployment used. "Out of the box"
the driver is in the correct position for "portrait" use and must be rotated through 90° for
"landscape" use. Please see page 13 for details of driver rotation.
Offer the cabinet up the ceiling bracket arm and mate the cabinet bracket section with the
ceiling bracket arm by threading the M6 bolt with spring washer through the cabinet bracket
as shown below. Do not fully tighten the bolt at this stage, leave a little play so the vertical
dispersion can be adjusted.
CDD User Guide V1.1
32
Advertisement
Table of Contents
