Electrolux ICON E23BC79SPS6 Use And Care Manual page 8

Installation
8
3 Ensure both doors are bind-free with
their seals touching the cabinet on all
four sides and that cabinet is stable.
4 After unit is leveled, lower anti-tip leg
using a 3/8 inch socket wrench until
it firmly contacts the floor.
5 Install the toe grille by fitting into place.
To make final door height adjustments:
1. Open freezer drawer to make lower
hinge visible.
2. Insert 6mm Allen wrench into the
shaft of the lower hinge.
3. Adjust the height by turning clockwise
or counterclockwise. Turning
clockwise will lower the door. Turning
counterclockwise will raise the door.
Default setting is to the lowest height
when you receive your appliance.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(2) Retaining Clips
Door Door
Raise
To adjust the flipper mullion:
1 Loosen the screw located on the
flipper mullion hinge.
Flipper
Mullion
Hinge
Adjusting Flipper Mullion Screw
2 Adjust flipper mullion height. For
proper connection with the flipper
mullion guide, there should be a
separation about the thickness of
a coin (0.060 inches, or 1.5 mm)
between the guide and flipper
mullion.
Flipper
Mullion
Adjusting Flipper Mullion Height
3 Re-tighten screw.
Installing Shelves (select
models)
Your refrigerator was shipped with the
shelf hanger and glass shelves in a
shipping pack. Below are the instructions
to install and remove the shelves in your
desired locations.
1 Place top hooks of the hanger into
the desired slot, and lower straight
down until lower hooks rest on the
ladder.
Flipper
Mullion
Screw
Mullion
Guide
Thickness
of a Coin