Electrolux ICON E23BC79SPS6 Use And Care Manual page 13

To reinstall the refrigerator
doors:
IMPORTANT
When replacing the doors on the lower
hinge, they must be installed at a 90
degree angle.
1 Replace the lower hinge screws.
2 Holding the door at a 90 degree
angle, drop the pin down into the
center hinge opening. Rotate it
slightly in either direction until the
door falls down into place.
Doors
at 90º
3 Reinstall top hinge.
4 Insert the water line in the top left
tunnel pushing from the front to the
back of the unit.
Insert
tube up
to the
marking
line
Press
Press
Water
Line
NOTE
When reinserting the water tube and
replacing the top hinge cover, use care
to be sure you do not kink the tube.
Removing the Doors
Pin
Mechanism
(Door Bottom)
Bottom
Hinge
Opening
Water
Line
NOTE
Upon replacement, the tube needs to be
fully inserted up to the marking line.
5 Reconnect the harnesses.
6 Replace the top hinge covers.
7 Reconnect electrical power cord to
the wall outlet.
To reset door pin:
If doors are removed at less than a 40
degree angle, the pin returns to the home
position. It can be reset by turning the
door upside and using a 5/32" Allen
wrench to rotate the left hand pin 90
degrees clockwise and the right hand pin
90 degrees counterclockwise.
For
RIGHT DOOR,
turn pin 90˚
counter-
clockwise
Once the door pins are reset, follow the
steps "To reinstall the refrigerator doors".
For
LEFT DOOR,
turn pin 90˚
clockwise
13