Advertisement
Important Safety Instructions
• When placing the iron on its stand, ensure that
the surface on which the stand is placed is stable.
• The plug must be removed from the socket-outlet
before the water reservoir is filled with water.
• The surfaces with
• To have a electronic copy of the instruction manual
contact the after sales service in guarantee card.
• The iron must be used and rested on a stable surface.
Chapter 1: Preparation for Use
Due to the powerful output of steam, Hoover recommends
the use of an active ironing board with blowing and vacuuming
function which allows escape of any excess steam.
Place the ironing system on a stable and level surface, for example
on the hard part of an ironing board or on a heat-resistant surface.
IMPORTANT: Ensure your appliance is unlocked before switching
the power on (Fig 4).
Chapter 1.1 : What Kind of Water May be Used?
The Hoover ironing system has been designed to be used with tap water only.
There is no need to use distilled or pure distilled water.
Nevertheless, in case you live in a hard water area, you can mix 50% of distilled water with 50% of tap water.
Do not use any other kind of water or do not add other contents to water tank as it can damage your appliance.
Chapter 1.2 : Filling the Water Tank
Switch off the appliance and unplug it.
Open the water tank cap (7) to gain access to the water tank.
Fill the tank with Tap water and ensure you do not exceed the MAx mark.
WARNINg: Do not add vinegar, hot water, perfume, or any other kind of
chemical agents or any other contents in the water tank. It could damage
the steam generator and shorten its life use.
Chapter 1.3 - Switching on the Appliance
Connect the appliance with the mains cord to the earthed socket, the light (13) will flash with red meaning that
the appliance is in standby status. Press on the switch, the light will turn green meaning that the appliance is
switched on. Turn the temperature dial (12) to your desired setting, the iron light (10) illuminates meaning the
soleplate is heating up.
After approximately 3 minutes , the light (13) will stop flashing and remain constant. You can now start ironing
and if you require steam press the steam trigger (11).
4
are liable to get hot during use.
1
Fig. 4: Unlock & Switch on Iron System
1
2
3
Fig. 5: Water Tank Filling
Advertisement
