Table of Contents
Advertisement
1
Using the wall profile holes as a guide, drill the 3mm holes and then
secure the fixed panel using the 10mm M3.5 screws and washers then
push on the cover caps.
Ensuring the washer is in place, lower hinge panel into bottom hinge.
Check glass gasket & top bearing washer are fitted as shown, hold panel
upright in place & fit top hinge with 2x 30mm M4 screws.
1. Fit the hinge seal into the
groove on the hinge profile.
2. Slide the fixed panel assembly
into the wall profile and position
so that the bottom of the panel
sits on the rim of the bathtub &
is plumb.
2
Advertisement
Table of Contents
