Table of Contents
Advertisement
IMPORTANT NOTES :
Please Read Carefully & retain these instructions for Future Reference.
1.
For ease & safety we advise that two persons assemble this product.
2.
Protect bathtub surfaces at all times.
3.
Check for cables, pipes etc before drilling walls.
4.
Ensure all surfaces are dry, clean & free of loose debris / dust.
5.
Unpack goods with care (small parts can become lodged in packaging &
inadvertently discarded). Check parts supplied against parts & fittings listed herein.
Damaged parts / omissions may be resolved by calling Lakes Bathrooms Helpline.
6.
Whilst precautions are taken in manufacture, care must be taken when handling as
rail ends may have sharp edges.
7.
Before commencing, check :
a)
bathtub is level & completely sealed to finished / tiled walls.
b)
finished walls are sound & free of cracks loose tiles / grout.
8.
AFTER INSTALLATION, DO NOT 'WET' ENCLOSURE FOR 48 HOURS (ENSURE FULL CURE
OF SILICONE SEALANT).
USE :
General Care & Maintenance.
Provided this product is installed & operated in accordance with these instructions, problems
should not arise. However should maintenance be required it should be carried out by a
competent person with reference to these instructions. Before any work is carried out the
root cause of the problem must be identified. Lakes Bathrooms service engineers are
available if necessary to consult / carry out remedial work. Call Lakes Bathrooms HELPLINE.
Cleaning.
(
Every one to two weeks depending on local water {hardness} conditions).
All glass panels in this product have a hydrophobic coating aiding 'runoff' of water droplets,
reducing the need for frequent cleaning. For best appearance / product life however, regular
cleaning is recommended.
Use ONLY mild soap / detergent solutions to clean. Rinse with water, squeegee glass panels
& wipe frames dry with a soft cloth. Under no circumstances should abrasive, caustic or
scouring products be used. DO NOT use 'spray & leave' type cleaning products.
Non compliance with these cleaning instructions may cause plated / painted finishes to
deteriorate & could adversely affect safe operation of the enclosure.
Advertisement
Table of Contents
