Enclosure Requirements - Bosch Evolution SGE63E05UC Installation Instructions Manual

WARNING
Avoid Scalding or Electrical Shock Hazard!
Make sure the water supply and electrical supply are
shut off before installation or service.
NOTE: This dishwasher is designed to be enclosed on the top
and both sides by standard residential kitchen cabinetry.
Select a location as close to the sink as possible for easy
access to water supply and drain lines.
For proper dishwasher operation and appearance, ensure
that the enclosure is square and has the dimensions shown
in Figure 1 below.
If the dishwasher is to be installed in a corner, make sure that
there is adequate clearance to open the door. See Figure
2 below.
Check clearance
between
dishwasher door
and wall
WARNING
Avoid Electrical Shock/Fire Hazard
Do not allow the electrical and water supply lines
6

Enclosure Requirements

90°
Countertop
to touch.
After locating the proper place for your new dishwasher,
you will need to make any required openings to allow for
passage of the water, drain and electrical line. In order to
avoid interference with the dishwasher when sliding it into the
cabinet, place your openings within the dimensions shown
in Figure 3 below.
Required Openings:
4 1 / " x 2" (108 x 52mm) - To pass the included electrical
4
4" x 2" (100 x 50mm) -
1
1 / " (32mm) diameter -
4
NOTE: If the incoming electric supply, water supply and
drain connections are all in the same cabinet, the one
4 1 / " x 2" (108 x 52mm) hole will be large enough for all three
4
to pass through.
Before sliding the dishwasher into the cabinet, remove the
hose clip at the back of the dishwasher, as shown below
and discard.
supply junction box through to
an adjacent cabinet
To pass the included water
supply line toward the water
supply
To p a s s t h e d i s h w a s h e r
drain hose toward the drain
connection