Connecting To An Antenna Or Cable; Remote Control; Other Connections - LG 49LJ540T Easy Setup Manual

• If you connect a gaming device to the TV, use the
cable supplied with the gaming device.
• Refer to the external equipment's manual for
operating instructions.
• In PC mode, there may be noise associated
with the resolution, vertical pattern, contrast
or brightness. If noise is present, change the PC
output to another resolution, change the refresh
rate to another rate or adjust the brightness and
contrast on the Picture menu until the picture
is clear.
• When connecting via a wired LAN, it is
recommended to use a CAT 7 cable.

Connecting to an Antenna or Cable

Connect an antenna, cable, or cable box to watch
TV while referring to the following. The illustrations
may differ from the actual items and an RF cable is
optional.
• Make sure not to bend the copper wire of the RF
cable.
Copper wire
• Complete all connections between devices, and
then connect the power cord to the power outlet
to prevent damage to your TV.
• To improve the picture quality in a poor signal
area, purchase a signal amplifier.
• Use a signal splitter to use 2 TVs or more.
• If the antenna is not installed properly, contact
your dealer for assistance.
• DTV Audio Supported Codec (Depending upon
country) : MPEG, AAC, HE-AAC, Dolby Digital,
Dolby Digital Plus

Other Connections

Connect your TV to external devices. For the best
picture and audio quality, connect the external
device and the TV with the HDMI cable.
• HDMI Audio Supported Format:
DTS (44.1 kHz / 48 kHz), Dolby Digital / Dolby
Digital Plus (32 kHz / 44.1 kHz / 48 kHz), PCM
(32 kHz / 44.1 kHz / 48 kHz / 96 kHz / 192 kHz)
(Depending upon model)
8

Remote Control

(Some buttons and services may not be provided
depending upon the model or region.)
The descriptions in this manual are based on
the buttons on the remote control. Please read
this manual carefully and use the TV correctly. To
install batteries, open the battery cover, replace
batteries (1.5 V AAA) matching the
to the label inside the compartment, and close
the battery cover. Failure to match the correct
polarities of the batteries may cause the battery
to burst or leak, resulting in fire, personal injury,
or ambient pollution. To remove the batteries,
perform the installation actions in reverse. This
remote uses infrared light. When in use, it should
be pointed in the direction of the TV's remote
sensor.
3
4
A
(Power) Turns the TV on or off.
Returns to the last TV channel.
Toggles between Radio, TV, CATV,
and DTV.
Activates or deactivates the subtitles.
Activates your preferred subtitle in
digital mode.
(Q.Settings) Accesses the Quick Settings.
(Search) Shows the search mode.
(Input) Changes the input source.
Number button Enters numbers.
and ends
A