Installing Ddr Module; Jumpers, Headers, Connectors & Slots - Biostar P4TSE Pro Description

Symmetrical DIMM population and matched double-sided DIMMs
Lightly loaded configuration
Dual Channel Configuration Table
Dual Channel Configuration Table
DIMM Slot DDRA1
Lightly 128MB --
Loaded 1GB
Config
Lightly
Loaded
Config
Fully Loaded 128MB --
Config 1GB
DRAM Access Time: 2.5V Unbuffered/ no registered (without ECC) DDR SDRAM
DRAM Type: 128MB/ 256MB/ 512MB/ 1GB DIMM Module (184 pin)

Installing DDR Module

1. Unlock a DIMM slot by pressing the retaining clips
outward. Align a DIMM on the slot such that the
notch on the DIMM matches the break on the slot.
2. Insert the DIMM vertically and firmly into the slot
until the retaining chip snap back in place and the
DIMM is properly seated.
Jumpers, Headers, Connectors & Slots
Floppy Disk Connector: FDD1
The motherboard provides a standard floppy disk connector that supports 360K,
720K, 1.2M, 1.44M and 2.88M floppy disk types. This connector supports the
provided floppy drive ribbon cables.
DDRA2 DDRB1
128MB --
1GB
128MB --
1GB
128MB -- 128MB --
1GB 1GB
PC2100/ PC2700/ PC3200 Type required.
8
DDRB2 System
Density
256MB --
2GB
128MB -- 256MB --
1GB 2GB
128MB -- 512MB --
1GB 4GB