Appendix: E-Sata Connection - Speco D8HS2TB User Manual

8. Port forward the NETWORK PORT (Default: 5445) and WEB PORT (Default: 80) of the private IP
Address of the DVR on the network router.
Please refer to the user manual and guide for the detailed steps for port forwarding for
specific router model.
6. Run the network client software.
7. Input Site Name, Site Address (IP address), Port No., and Password on the connect window.
 Site Name: Input a name that properly describes a site.
IP Address: Domain name or Public IP address of a router that DVR is connected.

Port Number: Default Port Number is "5445".

ID: Input ID of DVR. Default ID is "admin".

Password: Input network password of DVR. Default Password is "1111".

8. And select the OK button. Then, press

APPENDIX: E-SATA CONNECTION

Please read the following instructions before using the E-SATA port.
SPECO is not responsible for data loss caused by improper usage.
 Use ONLY a new HDD or a HDD that is approved for the unit.
 Turn off the DVR before plugging the E-SATA HDD.
 DO NOT disconnect the E-SATA port while the DVR power is on.
 The purpose of the E-SATA port is to extend recording capacity.
 Once connected, DO NOT Remove or disconnect the E-SATA port from the DVR.
The E-SATA port is does not support the hot swappable function.

Failure to do so may cause serious damage to the recorded video.
button after checking the left check box.
107