Protection Control - Panasonic CS-E15GKEW Service Manual

Troubleshooting Method
• Press "e-ion" button or "OFF/ON" button to stop the operation and check the e-ion Air Purifying system main connector to
PCB.
• After that, press "e-ion" button again to confirm the e-ion indicator not blinking.
• The 24 times counter will be clear after 10 minutes of normal operation or when operation stops.
Error Reset Method
• Press "OFF/ON" button to OFF the operation.
• Press AUTO OFF/ON button at indoor unit to OFF the operation.
• OFF Timer activates.
• Press "e-ion" button during e-ion individual mode.
• Power supply reset.
iii. e-ion breakdown
Judgement Method
• When hi-feedback voltage (at microcontroller) supplied to filter during e-ion stop, due to PCB or filter's high voltage power
supply damage.
• Operations except e-ion continue. Both Timer indicator and e-ion indicator blink.
Troubleshooting Method
• Press "e-ion" button or "OFF/ON" button to stop the operation.
• Change main circuit board or filter's high voltage power supply.
• When lo-feedback voltage supplied to e-ion Air Purifying system during e-ion operation, e-ion indicator and Timer indicator
stop blinking.

12.2. Protection Control

12.2.1. Protection Control For All Operations
12.2.1.1. Time Delay Safety Control
1. The compressor will not start for 3 minutes after stop of the operation.
2. This control is not applicable if the power supply is cut off and on again or after 4-way valve deices condition.
12.2.1.2. 30 Seconds Forced Operation
1. Once compressor starts the operation, it will not stop its operation for 30 seconds.
2. However, it can be stopped with the remote control or the Auto Switch on the indoor unit.
12.2.1.3. Total Running Current Control
1. When the outdoor unit total running current (AC) exceeds X value, the frequency instructed for compressor operation will be
decreased.
2. If the running current does not exceed X value for 5 seconds, the frequency instructed will be increased.
3. However, if total outdoor unit running current exceeds Y value, compressor will be stopped immediately for 3 minutes.
4. The first 30 minutes of cooling operation, (A) will be applied.
Model
Operation Mode
Cooling/Soft Dry (A)
Cooling/Soft Dry (B)
Heating
E15GK
X (A) Y (A)
7.52 15.0
7.16 15.0
8.55 15.0
53