Table of Contents
Advertisement
UR2 Duplex Mode
Select the value required by the IR device connected to the IR port.Full-duplex Mode
permits simultaneous two-direction transmission.Half-duplex mode permits transmission
in one direction only at a time.
The Choices: Half (default), Full.
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with which I/O
Address.
The Choices: 378/IRQ7 (default), 278/IRQ5, 3BC/IRQ7, Disabled.
Parallel Port Mode
The default value is SPP.
The Choices:
SPP(default)
EPP
ECP
ECP+EPP
ECP Mode Use DMA
Select a DMA Channel for the port.
The Choices: 3 (default), 1.
POWER After PWR-Fail
This setting specifies whether your system will reboot after a power fail or interrupts
occurs.
Off Leaves the computer in the power off state.On Reboots the computer.
Former-Sts Restores the system to the status before power failure or interrupt occurs.
The Choices: Off (default), On, Former-Sts.
N4SIE-A7
Using Parallel port as Standard Printer Port.
Using Parallel Port as Enhanced Parallel Port.
Using Parallel port as Extended Capabilities Port.
Using Parallel port as ECP & EPP mode.
21
Advertisement
Table of Contents
