JUKI TSC-441 Instruction Manual page 32

BEFORE OPERATION
CAUTION :
Check the following so as to prevent maloperation of and damage to the machine.
• Before you put the machine into operation for the first time after the set-up, clean it thoroughly.
Remove all dust gathering during transportation and oil it well.
• Confirm that voltage has been correctly set.
Confirm that the power plug has been properly connected to the power supply.
• Never use the machine in the state where the voltage type is different from the designated one.
• The direction of normal rotation of the machine is counterclockwise as observed from the
pulley side.
Take care not to allow the machine to rotate in the reverse direction.
• Never operate the machine unless the sewing machine have been filled with oil.
• For a test run, remove the bobbin and the needle thread.
• For the first month, decrease the sewing speed and run the sewing machine at a speed of 600
sti/min or less.
• Operate the handwheel after the machine has totally stopped.
CAUTION :
Note that safety devices such as "eye guard", "finger guard", etc. may be omitted from the
illustrations in this Instruction Manual for easy explanation.
When operating the machine, be sure not to remove these safety devices.
vi