Adjusting Your Monitor Image; Using The Direct Access Controls - Lenovo C24-20 User Manual

Adjusting your monitor image

This section describes the control features to adjust your monitor image.

Using the direct access controls

The direct access controls can be used when the On-Screen Display (OSD) is not displayed.
1
2
3
4
Icon Control
Input Source
Exit
Auto Adjustment
Increase
Brightness
Enable Low Blue Light
Disable Low Blue Light
Decrease
Menu/OK
Enter
Description
Switches the video input source
Shift back to previous level when in OSD mode
Shortcut key for directly opening the menu of source-
selecting while there is no any OSD on the screen.
Press to exit current OSD or return to previous level.
Press and hold for 10 seconds, then the DDC/CI
function will be Enabled/Disabled.
Optimizes image (size, position, phase and clock) (For
analog [VGA] source only)
Press to move to last item on menu.
Press to Increase current value on adjustment bar.
Shortcut key for directly opening brightness adjustment
bar while there is no any OSD on the screen.
Press and hold for 3 seconds to enable Low Blue Light
Press and hold for 3 seconds to disable Low Blue Light
Press to move to next item on menu.
Press to decrease current value on adjustment bar.
Press to open main menu while there is no any OSD on
the screen.
Press to enter next level on main menu or sub menu , or
enter previous level on adjustment bar.
Press and hold for 10 seconds, then Main menu will be
Locked/un-Locked.
Press to enter next level on main menu/sub menu status
or enter previous level on adjustment bar
2-3
Chapter 2.