Dometic WAECO CF18 Operating Manual page 19

CF18 – CF60
I
NOTE
The temperature displayed is that of the middle of the interior.
The temperatures elsewhere can deviate from this temperature.
✓ The cooler starts cooling the interior.
I
NOTE
During low voltage:
If switched off by the battery monitor due to low voltage, the display
goes blank, and the LED "POWER" flashes orange.
Latching the cooler lid (CF35, CF40)
➤ Close the lid.
➤ Press the latch (fig. 2 1, page 9) down, until it latches in place audibly.
7.6 Setting the temperature
A
NOTICE! Danger from excessively low temperature!
Ensure that the only those objects are placed in the cooler that are
intended to be cooled at the selected temperature.
CF18
➤ Set the cooling level with the temperature controller (fig. 3 1, page 9).
CF25, CF35, CF40, CF50, CF60
➤ Press the "SET" button (fig. 4 4, page 10) once.
➤ Use the "UP +" (fig. 4 6, page 10) and "DOWN –" (fig. 4 7, page 10) buttons
to select the cooling temperature.
✓ The cooling temperature appears in the display for a few seconds. The display
flashes several times and then the current temperature is displayed again.
7.7 Using the Emergency Switch
The emergency override switch (fig. 5 2, page 11 and fig. 6 4, page 11) is located
in the connection panel.
➤ For normal operation the switch should be in the NORMAL USE position.
EN
Operation
19