Autotek Mean Machine MM1-1000D User Manual page 7

MM1000.1D / MM1500.1D / MONO AMPLIFIER APPLICATIONS
Master / Slave Application
DUAL AMP INSTALLATION PROCEDURE:
1. Connect the amp LINE INPUTS to the Radio/CD player full range or mono
line out puts with good quality RCA interconnect cables.
2. Plug the bass remote module into the amp REMOTE input jack. This will allow
the Master amp to control both Master and Slave amps with just one Bass
Remote.
3. Connect an RCA jumper cable from the Master amp MASTER OUTPUT to
the Slave amp SLAVE INPUT. Note: This will "link" the amps so that the Master
amp crossover switches will control both the Master and Slave amps. The Slave
amp crossover switches will be bypassed.
4. Route two 2 gauge power cables directly to the vehicle battery with an in-line
fuse.
DESIGNATED
MONO
LINE INPUT
utotek
a
0dB 18dB
MMR-1
+12V REM GND
+ + -
BRIDGED
PROTECT
FUSE
POWER INPUT SPEAKER OUTPUT
Linking two amps for single or dual subwoofer application
Amplifiers can run at a 2ohm
load minimum when linked
MASTER
SLAVE
+12V REM GND
- +
BRIDGED
PROTECT
FUSE
POWER INPUT SPEAKER OUTPUT
Dual 1ohm Voice Coil
Minimum
5. Connect two 2 gauge ground cables directly to chassis ground with in 36" of
the amp.
- Be sure to remove any paint or primer from the ground point.
- Use a nut, bolt and lock washer to secure the ground cable to the chassis
ground.
6. Make sure the Master amp MASTER/SLAVE switch is in the MASTER
position. Make sure the Slave amp MASTER/SLAVE switch is in the SLAVE
position.
7. Connect the subwoofer(s) in accordance to the diagrams below.
8. Connect a 12 gauge jumper from Master amp speaker - to Slave amp speaker
- as shown below.
9. Connect Bridged Protect RCA cable from Master to Slave amplifier.
+12V REM
+ - -
FUSE
POWER INPUT
GND
+ + - -
BRIDGED
PROTECT
FUSE
SPEAKER OUTPUT
Two Subwoofers,
Minimum 1ohm load
Per Amplifier
+ -
+12V REM GND
+ + - -
BRIDGED
PROTECT
POWER INPUT SPEAKER OUTPUT
+ -
5