McGREGOR MEH1430A Original Instruction Manual page 7

Safety Information
Important - Please read these instructions fully before starting assembly
Personal Safety (continued)
electric shock. The maximum operating current of the
RCD must be less than 30mA.
• The voltage indicated on the rating plate must
correspond to the voltage of the power source.
• Only use or replace power supply cables for this
unit which correspond to the types indicated by the
manufacturer. See the operating instructions for the
order no. and types.
• Never touch the mains plug with wet hands.
• Do not run over, crush or pull the power supply cable or
extension lead, otherwise it may be damaged. Protect
the cable from heat, oil and sharp edges.
• The extension lead must have a cross section in
accordance with the operating instructions and be
protected against splashed water. The connection must
not be in water.
POWER TOOL USE AND CARE
• Do not force the power tool. Use the correct power tool
for your application. The correct power tool will do the
job better and more safely when operated at the rate for
which it was designed.
• Do not use the power tool if the switch does not turn it
on and off. Any power tool that cannot be controlled with
the switch is dangerous and must be repaired.
• Disconnect the plug from the power source and/ or the
battery pack from the power tool before making any
adjustments, changing accessories, or storing power
tools. Such preventive safety measures reduce the risk
of starting the power tool accidentally.
Customer Helpline 0345 605 2063 7