Table of Contents
Advertisement
MD-R2H
10. INNER mode
Step No.
Setting Method
Step 1
Testmode STOP state
Step 2
Press the NAME/TOC EDIT button. INNER menu
Step 3
Press once the MD PLAY button. INNER switch position measurement
Step 4
Press once the MD STOP button. INNER menu
•
: Adress
• Press the MD STOP button while the INNER menu is displayed, to shift to the TEST mode STOP state.
11. EJECT mode
Step No.
Setting Method
Step 1
Testmode EJECT state
Step 2
Press oncethe DISPLAY/
CHARACTER button.
Step 3
Press once the DISPLAY/
CHARACTER button.
Step 4
Press once the DISPLAY
CHARACTER button.
Step 5
Press the DELETE/CLEAR button. TEMP setting of EEPROM setting
Step 6
Press the NAME/TOC EDIT button. CONTROL setting of EEPROM setting
Lead-in switch position measurement mode
Note: Adjust the lead-in switch position to 5FF85 to FFD2.
1. Loosen the screw (A) x 3 pcs. which fix the mechanism switch PWB.
2. Retighten the screw, pressing the mechanism switch PWB in the arrow direction, and then measure the lead-in switch position again.
After position adjustment fix with the three screws (A). (See Fig. 22.)
Note: After tightening the two screws on the PWB apply Screw Lock.
Forced rotation of loading motor
While the display indication is test mode STOP state or EJECT state,
the loading motor can be forcibly rotated by press theVOL UP/DOWN
button.
(SUBQ address and C1 error are also indicated.)
Max. power output state
Record power output state
Playback power output state
(Refer to TEMP setting of EEPROM)
(Refer to CONTROL setting of EEPROM)
Loosen the
three screws (A).
Mechanism Switch PWB
Remarks
Remarks
Lead-In Switch
Figure 22
– 22 –
Display
[ t s m
e
]
[ _ _ I N N E R _ _ ]
[s
c
]
[ _ _ I N N E R _ _ ]
Display
[ _ _ E J E C T _ _ _ ]
[ x p w _ _ _ _ _ _ _ ]
[ r p w _ _ _ _ _ _ _ ]
[ p p w _ _ _ _ _ _ _ ]
Advertisement
Table of Contents
