Back Panel - Belkin F9K1102V3 User Manual

B) Wi‐Fi Protected Setup (WPS) Light and Button
The WPS button on the front of your Router can be used to help
establish a secure connection between your Router and other WPS‐
enabled Wi‐Fi devices such as computers. To use the WPS feature
on your Router, see "Getting Started > Adding Computers to Your
Network > Using the WPS Button".
The small light near the WPS button shows what is happening
while you are using WPS to establish a connection.
Off: Idle
Blinking Blue: The Router is listening for a WPS‐enabled computer or
other device.
Solid Blue: The Router has made a secure connection with the computer or
other device.
Amber: A connection was not created.

Back Panel

[R DIAGRAM FOR SHARE AND PLAY r_shareplay_back.ai]
A) Modem (WAN) Connector
Connect your modem to this port using an Ethernet cable.
B) Wired (LAN) Connectors
Connect computers and other wired network devices to these ports
using Ethernet cables.
C) USB Port
USB printers, disks, and other USB devices plugged into this port
will be shared on your network. Each USB port has a light that
indicates its status.
Off: No USB device is connected or the attached USB device is not in use.
Blinking: Please wait to unplug the device until the light turns off.
On: The USB device is connected and being shared on your network.