Connecting The Ac Power Cord - Sanyo PLC-XU4000 Owner's Manual

This projector uses nominal input voltages of 100-240 V AC
and it automatically selects the correct input voltage. It is
designed to work with single-phase power systems having a
grounded neutral conductor. To reduce the risk of electrical
shock, do not plug into any other type of power system.
If you are not sure of the type of power being supplied,
consult your authorized dealer or service center.
Connect the projector with all peripheral equipment before
turning the projector on.
CAUTION
The AC outlet must be near this equipment and must be
easily accessible.
Note:
Unplug the AC power cord when the projector is not
in use. When this projector is connected to an outlet
with the AC power cord, it is in Stand-by mode and
consumes a little electric power.
NOTE ON THE POWER CORD
AC power cord must meet requirement of the country where you use the projector.
Confirm the AC plug type with the chart below and proper AC power cord must be used.
If supplied AC power cord does not match your AC outlet, contact your sales dealer.
Projector side
For the U.S.A. and Canada
To power cord
connector on your
projector.

Connecting the AC Power Cord

Ground
To the AC outlet.
(120 V AC)
Connect the AC power cord
(supplied) to the projector.
AC outlet side
For Continental Europe
To the AC outlet.
(200 - 240 V AC)
Installation
For the U.K.
To the AC outlet.
(200 - 240 V AC)
17