Table of Contents
Advertisement
ENGLISH
Residual risks.
Additional residual risks may arise when using the tool
which may not be included in the enclosed safety warnings.
These risks can arise from misuse, prolonged use etc. Even
with the application of the relevant safety regulations and
the implementation of safety devices, certain residual risks
can not be avoided. These include:
•
Injuries caused by touching any rotating/moving parts.
•
Injuries caused when changing any parts, blades or
accessories.
•
Injuries caused by prolonged use of a tool. When using
any tool for prolonged periods ensure you take regular
breaks.
•
Impairment of hearing.
•
Health hazards caused by breathing dust developed
when using your tool (example:- working with wood,
especially oak, beech and MDF.)
Electrical safety
This tool is double insulated; therefore no earth wire
is required. Always check that the power supply
corresponds to the voltage on the rating plate.
•
If the supply cord is damaged, it must be replaced by
the manufacturer or an authorised STANLEY Service
Centre in order to avoid a hazard.
Labels on tool
The label on your tool may include the following symbols:
Hz ....... Hertz
Read
Instructions
W ........ Watts
Manual
min ..... minutes
Use Eye
Protection
..... Alternating
Use Ear
Protection
..... Direct
V ........ Volts
n
....... No-Load
0
A ........ Amperes
Position of date barcode
The Date Code, which also includes the year of
manufacture, is printed into the housing.
Example:
2014 XX JN
Year of manufacturing
6
(Original instructions)
...... Class II
Construction
....
Earthing
Terminal
....
Safety Alert
Current
Symbol
.../min..
Revolutions
Current
or Recipro-
cation per
minute
Speed
Features
This tool includes some or all of the following features.
1. On/Off switch
2. Speed selector dial
3. Drilling mode selector
4. Operating mode selector
5. Tool holder
6. Side handle
7. Depth stop
8. Grease cap
Assembly
Warning! Before assembly, make sure that the tool is
switched off and unplugged.
Fitting the side handle (fig. A)
•
Turn the grip counterclockwise until you can slide the
side handle (6) onto the front of the tool as shown.
•
Rotate the side handle into the desired position.
•
Tighten the side handle by turning the grip clockwise.
Fitting and setting the depth stop (fig. A)
•
Slacken the knob (9).
•
Insert the depth stop (7) into the mounting hole as
shown.
•
Set the depth stop (7) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
•
Tighten the knob (9).
Fitting an accessory (fig. B - D)
•
Clean and grease the shank (10) of the accessory.
•
Pull back the sleeve (11) and insert the shank into the
tool holder (5).
•
Push the accessory down and turn it slightly until it fits
into the slots.
•
Pull on the accessory to check if it is properly locked.
The hammering function requires the accessory to be
able to move axially several centimetres when locked in
the tool holder.
•
To remove the accessory, pull back the sleeve (11) and
pull out the accessory.
Advertisement
Table of Contents
