Table of Contents
Advertisement
4. Check if the LINK LED is solid blue (connection complete)
Rear of the
Left and Right
Surround Speakers
5. If the SWA-9500 does not connect, take the necessary steps according to the LED Indicator's status
On
LINK (Blue)
Blinking
STANDBY (Red)
On
Red and blue Blinking
-
Stops blinking.
Glows blue.
LED status
Successfully connected
(normal operation).
Recovering the connection.
Standby (with the Soundbar main
unit turned off).
Connection failed.
Malfunction
The LINK LED indicator stops blinking and glows a solid blue when a connection
is established between the Soundbar and the Surround Speakers.
-
Check if the power cable attached to the main Soundbar unit is
connected properly or wait about 5 minutes.
Repeat steps 2 through 4.
Check if the power cable attached to the main Soundbar unit
is connected properly.
1. Press the ID SET button on the back of the Surround
Speakers with a pen tip for 5~6 seconds until the LINK LED
indicator blinks (in Blue).
2. Repeat steps 2 through 4.
See the contact information for the Samsung Service Center in
this manual.
ENG - 15
Action
5 Sec
Advertisement
Table of Contents
