Connecting The Swa-9500 To A Soundbar - Samsung HW-Q870A Full Manual

• The maximum transmission distance of the main unit's wireless signal is about 10 m, but may vary depending on your operating environment.
If a steel-concrete or metallic wall is between the main unit and the wireless subwoofer, the system may not operate at all because the
wireless signal cannot penetrate metal.
CAUTION
• Wireless receiving antennas are built into the wireless subwoofer. Keep the unit away from water and moisture.
• For optimal listening performance, make sure that the area around the wireless subwoofer and the Wireless Receiver Module is clear of any
obstructions.

Connecting the SWA-9500 to a Soundbar

1. Check the standby status after plugging into an electrical outlet
Plug the Surround Speakers power cord into an electrical outlet and into the Surround Speakers to turn on the Surround Speakers. The LINK LED
indicator (blue LED) on the Surround Speakers blinks. If the LED does not blink, refer to step 5.
2. Turn off the Soundbar
Turn off the Soundbar using the Soundbar's remote control or by pressing the
• The image of the Soundbar may differ from your Soundbar, depending on the model.
3. Configure "ID SET" using the Soundbar's remote control
Press the Up button on the Soundbar remote control for 5 seconds.
• The ID SET message appears on the Soundbar main unit's display for a short time and then disappears.
• After the ID SET process, the Soundbar power is automatically turned on.
• The image of the Soundbar may differ from your Soundbar, depending on the model.
Bottoms of the Left and Right
Surround Speakers
Blinking blue fast
Rear of the Left
and Right Surround
Speakers
5 Sec
ENG - 14
(Power) button on the main Soundbar unit.
BYE
ID SET