Advertisement
Quick Links
Advertisement
Related Manuals for Trotec Bl20
Summary of Contents for Trotec Bl20
- Page 1 BI20 OPERATING MANUAL LOCATING DEVICE...
-
Page 2: Table Of Contents
Only use the device for locating power lines, studs and joists in walls whilst adhering to the technical data. To use the device for its intended use, only use accessories and spare parts which have been approved by Trotec. locating device BI20... -
Page 3: Information About The Device
Improper use Information about the device Do not use the device in potentially explosive atmospheres, for measurements in liquids or at live parts. Trotec accepts no Device description liability for damages resulting from improper use. In such a The device BI20 does not only reliably locate ferrous and non- case, any warranty claims will be voided. -
Page 4: Transport And Storage
Display Transport and storage Note ERROR If you store or transport the device improperly, the device may be damaged. Note the information regarding transport and storage of the device. Transport For transporting the device, use the bag included in the scope of delivery in order to protect the device from external influences. -
Page 5: Operation
3 sec 3 sec Selecting the measuring mode Operation 3 sec You can choose between the measuring modes Stud frame, Inserting the battery Power line and Metal. Insert the supplied battery into the device before first use. Measuring mode Icon Note Stud frame (timber/metal) Make sure that the surface of the device is dry and the... - Page 6 Performing a calibration Info During the calibration as well as the later measuring process you should ideally only hold the device with your fingertips at the lateral black gripping surfaces near the bottom of the device. After calibration and during subsequent measurements, try not to change the position of your hand or fingers.
-
Page 7: Maintenance And Repair
Info Info When an object is first approached or crossed, this is Please note that – being subject to wall structure and indicated by a rising bar graph and a change in the several superimposed material layers/object depth – audio frequency. When pulling the device back in the the bar graph will not always be indicated fully closed, opposite direction, its sensitivity is adjusted even in case of a precise localization! -
Page 8: Errors And Faults
Errors and faults The device has been checked for proper functioning several times during production. If malfunctions occur nonetheless, check the device according to the following list. Fault Cause Remedy The device can no The battery is dead. Insert a new battery longer be switched (see chapter Operation). - Page 9 Trotec GmbH Grebbener Str. 7 D-52525 Heinsberg +49 2452 962-400 +49 2452 962-200 info@trotec.com www.trotec.com...