Advertisement
Thank-you for your purchase of the Hogtunes 4th Gen speakers for "Rushmore"
platform bikes! Since positive word of mouth is the best way to grow our business,
we want your new speakers to work as well as they were designed to. If you have
any questions or concerns, we are here to help. Email tech@hogtunes.com or call
us during regular business hours at 608-554-7631 (US#) or 705-719-6361 (Canada #). If
you still need help, then please consider a professional installation by your dealer.
Front Speaker Instructions For 462F-RM In FLH (Batwing) Models:
Please Note That Road Glide Specific Fairing Instructions
Are On Page 4 Of This Manual!
Step #1: Make sure your ignition switch stays in the "OFF" position. Remove
your outer fairing/headlamp assembly and set aside. Refer to a service manual if
you need help with this. NOTE: Placing a towel on the front fender can help
prevent scratches or "dings" from dropped tools or fasteners, etc.
Step#2: Speaker Cabinet Removal: On the brake side speaker cabinet, carefully
remove the cable going into the power port/cigarette lighter assembly. If your
bike has the CB module (mounted "sideways" on the clutch side cabinet) undo
the antenna cable and main harness. The CB Module will stay attached to the
clutch side cabinet when removed. Undo the speaker wire plugs going into each
cabinet (pink & pink with black stripe wires).
NOTE: We STRONGLY suggest completing the speaker swap on one side and
then moving to other side! Figure 1.1 and 1.2 (below) have arrows that point to
the factory fasteners that will be removed to allow the cabinets to come out of
the bike. Although the Brake Side is shown below, fastener locations are
common for both brake and clutch side cabinets.
Figure 1.1 Side View of
Figure 1.2 Back View of
Brake side cabinet
Brake side cabinet
Advertisement
