Start-Up Procedures - MULTIQUIP WM-90PE Operation Manual

WM-90 PLASTER/MORTAR MIXER — START-UP PROCEDURE
This section is intended to assist the operator
with the initial start-up of the WM-90 mixer (with
gasoline engine or electric motor). It is extremely
important that this section be read carefully
before attempting to use the mixer in the field.
DO NOT use your mixer until this section is thoroughly
understood.
WARNING WARNING
WARNING WARNING WARNING
Failure to understand the operation of the WM-90 series
mixers could result in severe damage to the mixer or
personal injury .
See Figure 5 for the location of any control referenced in
this manual.
CAUTION CAUTION
CAUTION CAUTION CAUTION
NEVER operate the mixer in a confined
area or enclosed area structure that
does not provide ample free flow of air .
Start-up Procedure(Gasonline Engine)
The following steps outline the procedure for starting the
engine. Depending on the type of engine employed in the
mixer the steps may vary slightly. If your mixer has an electric
motor disregard this section.
1. Move the fuel shut-off lever (Figure 12) to the ON
position.
Figure 12. Fuel Shut-OFF Lever
PAGE 24 — WM-90 PLASTER/MORTAR MIXER — OPERATION MANUAL — REV. #1 (08/10/04)
Explosive Fuel
Hazard
Respiratory Hazard
2. To start a cold engine, move the choke lever (Figure
13) to the CLOSED position.
Figure 13. Choke Lever
3. Move the throttle lever (Figure 14) away from the slow
position, about 1/3 of the way toward the fast position.
Figure 14. Throttle Lever