Start-Up Procedures - MULTIQUIP STOW MS45H.5 Operation And Parts Manual

This section is intended to assist the operator with
the initial start-up of the MS-45H (gasoline) or
MS45E (electric) mixer. It is extremely important that
this section be read carefully before attempting to
use the mixer in the field.
DO NOT use your mixer until this section is thoroughly
understood.
CAUTION CAUTION
CAUTION CAUTION CAUTION
Failure to understand the operation of the MS45H/MS45E mixers
could result in severe damage to the mixer or personal injury.
See Figure 3 for the location of any control referenced in this
manual.
Starting (gasoline only)
The following steps outline the procedure for starting the engine.
Depending on the type of engine employed in the mixer the
steps may vary slightly. If your mixer has an electric motor
disregard this section.
1. Move the fuel shut-off lever (Figure 9) to the ON position.
Figure 9. Fuel Shut-OFF Lever
PAGE 22 — MQ STOW MS45H/MS45E MIXER — PARTS & OPERATION MANUAL — REV. # 2 (08/09/06)
MS45H/MS45E MIXER — START-UP PROCEDURES
2.
3.
To start a cold engine, move the choke lever (Figure 10) to
the CLOSED position.
Figure 10. Choke Lever
Move the throttle lever (Figure 11) away from the slow
position, about 1/3 of the way toward the fast position.
Figure 11. Throttle Lever