Electrolux GK78TSITO User Manual page 22

22 www.electrolux.com
Problem
The hob deactivates.
Residual heat indicator
does not come on.
Hob²Hood does not
work.
The sensor fields be‐
come hot.
There is no sound when
you touch the panel sen‐
sor fields.
comes on.
The control bar blinks.
and a number come
on.
You can hear a constant
beep noise.
Possible cause
You put something on the
control panel.
The zone is not hot be‐
cause it operated only for a
short time or the sensor is
damaged.
You covered the control
panel.
You use a very tall pot
which blocks the signal.
The cookware is too large
or you put it too near to the
controls.
The sounds are deactiva‐
ted.
Child Safety Device or
Lock operates.
There is no cookware on
the zone or the zone is not
fully covered.
The cookware is unsuita‐
ble.
The diameter of the bottom
of the cookware is too
small for the zone.
PowerSlide operates. Two
pots are placed on the flex‐
ible induction cooking area.
There is an error in the
hob.
The electrical connection is
incorrect.
Remedy
Remove the object from the
control panel.
If the zone operated suffi‐
ciently long to be hot, speak
to an Authorised Service
Centre.
Remove the object from the
control panel.
Use a smaller pot, change
the cooking zone or operate
the hood manually.
Put large cookware on the
rear zones, if possible.
Activate the sounds. Refer to
"Additional functions".
Refer to "Additional func‐
tions".
Put cookware on the zone so
that it fully covers the cook‐
ing zone.
Use suitable cookware. Re‐
fer to "Hints and tips".
Use cookware with correct
dimensions. Refer to "Tech‐
nical data".
Use only one pot. Refer to
"Daily use".
Deactivate the hob and acti‐
vate it again after 30 sec‐
onds. If comes on again,
disconnect the hob from the
electrical supply. After 30
seconds, connect the hob
again. If the problem contin‐
ues, speak to an Authorised
Service Centre.
Disconnect the hob from the
electrical supply. Ask a quali‐
fied electrician to check the
installation.