Mode Settings - Panasonic U-120ME2U9 Service Manual

6. Mode Settings

6. Mode Settings

Setting mode 1
<Operating procedure>
1. Press and hold the
(Ventilation) button simultaneously for 4
seconds or longer.
2. Press the temperature setting
buttons to change the item code. The item codes
and setting data are shown in the table below.
3. Press the timer time
change the setting data.
To confirm the changed setting data, press the
1
button.
(At this time, "
and remains lit.)
4. During this mode, "
blinking. The outdoor unit address display section
2
displays "ALL," the item code and number (DN
value in the table), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The
display changes between the first 3 digits (Fig. A )
and the last 3 digits (Fig. B
3
When the first 3 digits are displayed, the bottom dot
of the colon is illuminated.)
5. To exit the setting mode, press the
button.
4
5
DN
Regarding the parameter setting, see the item "13. Detailed Settings in EEPROM of Outdoor Unit" under
6
the Section 1.
7
8
9
(Check) button and
and
and buttons to
" display stops blinking
" is displayed,
).
(Check)
Item
Outdoor Unit Maintenance Remote Controller
Outdoor Unit Maintenance Remote Controller
A Display of fi rst 3 digits
2
A
3 5
B Display of last 3 digits
2
A
3 5
A and B are displayed alternately.
(Example shows display of 000 001.)
Setting No.
3 - 12
2WAY VRF SYSTEM
2WAY SYSTEM
1
1