The Default Setting Menu - Toshiba TDP-SP1U Owner's Manual

Using the menus (Continued)
■ The default setting menu
This menu shows placement status and other settings.
Item
Projection
mode
Auto input
search
Language
Start-up
screen
Fan mode
Lamp
power
Power on
Detailed description
[Auto input search]
Automatically searches the input source that can be projected, and switches source
from the connected device each time the INPUT button is pressed. If the connected
device outputs no source signal, the input is skipped. When the source signal is
stopped during projecting, it will switch to the other inputs automatically. If no input
sources are detected, it will stop searching and "No signal" message will appear.
[Fan mode]
Setting [Fan mode] to [High] increases the cooling fan speed. (The cooling fan
noise gets louder.) Set this option to use the projector, for example, at high altitude
(over 1,500m or 5000 ft. above sea level).
[Lamp power]
When [Lamp power] is set to [Low], the screen becomes a little darker, but the
cooling fan noise gets quieter.
[Power on]
If [Power on] is set to [Auto] and there is a power outage, the projector will come
on once power is restored.
Sets projection mode in accordance with Placement Style.
(Standard)
Sets whether the input source with signals is only selected or not.
Select one of the languages below to use for displaying the menu
and messages
[ : Enter setting mode]
English/Français/Deutsch/Italiano/Español/Português/
Svenska/Türkçe/Română/
Bahasa Indonesia/Norsk/Suomi/Čeština/Magyar/Ελληνικά/Dansk/
Nederlands
Sets whether the start-up screen displays when power is turned on.
Sets the cooling fan speed.
Sets the lamp power.
Sets whether to turn on the power when the ON/STANDBY button is
pressed (Manual), or when the power cord is plugged in (Auto).
Description
(Ceiling)
(Rear)
[
/
34
p.21
(Rear ceiling)
On
:Selection] [Apply:
/Polski/
On
Standard
Standard
Manual
Off
]
/
Off
High
Low
Auto.