Related Manuals for Bosch PRS9A6D70A
Summary of Contents for Bosch PRS9A6D70A
- Page 1 PPS9A6B90A This cooktop is approved for use with Natural Gas and Universal LPG. Leave these instructions with the owner. USER INSTRUCTIONS INSTALLATION INSTRUCTIONS MAINTENANCE INSTRUCTIONS...
-
Page 2: Table Of Contents
Additional information on products, accessories, replacement parts and services can be found at Do not use lids or protective barriers for www.bosch-home.com and in the online shop children which are not recommended by the www.bosch-eshop.com hob manufacturer. They may cause accidents such as those due to the overheating, ignition or detachment of fragments of materials. -
Page 3: Important Safety Information
Important safety information lack of experience and knowledge, unless (Important safety they have been given supervision or information instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do D O NOT MODIFY THIS APPLIANCE. -
Page 4: What To Do If You Smell Gas
Important safety information Do not store or use corrosive chemicals, What to do if you smell gas Risk of fire! ■ products which produce fumes, Do not try to light the appliance. inflammable materials or non-food products ■ Do not touch any electrical switch; do not below or near this domestic appliance. -
Page 5: Installation And Connection
Installation and connection Preparing to install 5Installation and connection Refer to AS/NZS 5601.1 for piping size details. These built-in cooktops are intended to be inserted in a S tatutory requirements benchtop cutout. I n s t a l l a t i o n a n d c o n n e c t i o n This installation must conform with the following: Do not stick the cooktop onto the worktop with silicone. -
Page 6: Clearances
Installation and connection Clearances Installation of cooktop into the kitchen bench A range hood fitted above the top must be installed according to the installation instructions for the range Side clearances: If the distance measured from the hood. A minimum distance of 650 mm is required for a periphery of the nearest burner to any vertical surface is range hood and 750 mm for an exhaust fan. -
Page 7: Electrical Connection
Installation and connection Electrical connection B) Flush installation Complete a normal installation of the appliance An electrical 10 amp socket needs to be within 1 m of making sure that it is surrounded by a uniform slot. the hotplate to allow electrical connection. The socket The hob surface should be slightly below the work must remain accessible after installation of the surface. -
Page 8: Gas Connection
Installation and connection Gas connection deformation and should be able to be inspected along its entire length with the cooktop in the During the planning stage, consider the position of installed position. Unions compatible with the hose supply connections. fittings must be used and all connections tested for gas leaks. - Page 9 Installation and connection Remove all pan supports, burner caps and If necessary, use a Torx screwdriver to adjust the distributors. bypass screws: To replace the injectors, use the key that is available A: For ULPG the bypass screws must be tightened from our technical service with code 340847 (for properly.
-
Page 10: Getting To Know Your Appliance
Getting to know your appliance It is essential to ensure that all the burner parts and pan *Getting to know your supports are correctly installed for the appliance to appliance work correctly. Do not swap the burner caps around. Always remove the pan supports carefully. When moving a pan support, the pan supports next to it may B urner locations also move. -
Page 11: Gas Burners
Gas burners Safety system Simmer cap Burner cap that is used only Your hob is equipped with a safety system when cooking at minimum out- (thermocouple) that cuts off the gas when the burners put. The simmer cap must be are accidentally switched off. -
Page 12: Settings Table And Tips
Settings table and tips Do not place anything, eg. JSettings table and tips flame tamer, asbestos mat, between pan and pan S uitable pans support as serious S e t t i n g s t a b l e a n d t i p s damage to the appliance Burner Minimum diame-... - Page 13 Settings table and tips Example: Meal Total Step 1 Step 2 time in Burner ˜ § v ˜ § v Meal Total Step 1 Step 2 min. time in Burner ˜ § v ˜ § v Rice min. High-output 17-22 12-15 ›...
- Page 14 Settings table and tips Meal Total Step 1 Step 2 Meal Total Step 1 Step 2 time in time in Burner Burner ˜ § v ˜ § v ˜ § v ˜ § v min. min. Standard-out- 8-13 8-13 š Eggs put burner Shakshuka...
- Page 15 Settings table and tips Meal Total Step 1 Step 2 Meal Total Step 1 Step 2 time in time in Burner Burner ˜ § v ˜ § v ˜ § v ˜ § v min. min. Fried sausages (x 12) Bread pudding High-output 5-10...
-
Page 16: Cleaning And Maintenance
Cleaning and maintenance Caution! 2Cleaning and maintenance Do not remove the control elements when cleaning ■ the appliance. The appliance may be damaged if moisture finds its way inside. C leaning C l e a n i n g a n d m a i n t e n a n c e Do not use steam cleaners. -
Page 17: Customer Service
Customer service Fault Possible cause Solution The kitchen smells of gas. A gas tap has been left on. Turn off the taps. Incorrect coupling of gas cylinder. Check that the coupling is sound. Possible gas leak. Shut off the gas supply, ventilate the premises and imme- diately notify an authorised installation technician to check and certify the installation. - Page 20 Robert Bosch Hausgeräte GmbH Carl-Wery-Straße 34 81739 München, GERMANY www.bosch-home.com *9001250972* 9001250972 970620(B)