Replacing The Oven Light; Replacing The Charcoal Filter; Cleaning The Grease Filter - Samsung SMH1927S/XAA User Manual

REPLACING ThE OvEN LIGhT

When replacing the oven light, make sure that you are
wearing gloves to avoid injury from the heat of the bulb.
1. Unplug the oven or turn off the power at the main
power supply.
2. Open the door.
3. Remove the vent cover mounting screws (2 middle
screws).
4. Slide the vent grille to the left, then pull it straight out.
5. Remove the charcoal fi lter, if present.
6. Remove the cover by pushing the hook and pulling up
the lever.
7. Remove the bulb by turning it gently.
8. Replace the bulb with a 40 watt appliance bulb.
9. Replace the bulb holder.
10. Replace the vent grille and the 2 screws.
11. Turn the power back on.

CLEANING ThE GREASE fILTER

Your microwave oven has two metal reusable grease
fi lters. The grease fi lters should be removed and cleaned
at least once a month, or as required.
To avoid risk of personal injury or property damage,
do not operate the oven hood without the fi lters in
WARNING
place.
1. To remove the fi lter, slide it to the left (or right) using
the tab.
2. Soak the grease fi lter in hot water and a mild
detergent. Rinse well and shake to dry. Brushing the
fi lter lightly can remove embedded dirt.
Do not use ammonia or put the grease fi lter in the
microwave oven. The aluminum will darken.
WARNING
22_ troubleshooting
SMH2117S_XAA_EN.indd 22
3. To return the fi lter to its position, slide it into the frame
slot on the left (or right), then push it upwards and to
the right (or left) to lock it.

REPLACING ThE ChARCOAL fILTER

If your oven is vented to the inside, the charcoal fi lter
should be replaced every 6 to 12 months and more often
if necessary. The charcoal fi lter cannot be cleaned. To
order a new charcoal fi lter, contact the Parts Department
at 1-800-627-4368 or your Samsung dealer. You can also
order online at www.samsungparts.com
1. Unplug the oven or turn off the power at the main
power supply.
2. Open the door.
3. Remove the vent grille mounting screws (2 middle
screws).
4. Slide the vent grille to the left, then pull it straight out.
5. Push the hook and remove the old fi lter.
The fi lter angle
The angle The angle
6. Slide a new charcoal fi lter into place. The fi lter should
rest at the angle shown.
7. Replace the vent grille and 2 screws and close the
door. Turn the power back on and set the clock.
The fi lter angle
2011-08-08 9:16:02