Table of Contents
Advertisement
Mounting in a CAB-200 Backbox
The Auxiliary Power Supply is mounted as shown in the figure below.
To mount the APS-6RF, follow these instructions:
Step
1
2
3
4
5
6
APS-6RF
Assembly
APS-6RF Instruction PN 50893:B 7/20/00
Appendix A: Sensiscan 200
Action
Remove plastic cover from APS-6RF.
If 240 VAC is to be used, cut JP1 jumper at this time. See "Configuring the
APS-6RF" on page 15.
Place the APS-6RF onto the mounting studs in the backbox.
Insert a standoff through each of the printed circuit board mounting holes,
threading each standoff to the mounting studs.
Tighten the standoffs until the APS-6RF is securely fastened to the
backbox.
Reinstall the plastic chassis cover.
CAB-200
Backbox
Figure 9 Mounting an APS-6RF to a CAB-200 Backbox
Mounting
Studs
Standoff
(2 places)
17
Advertisement
Table of Contents
