Napoleon High Country 5000 Installation Manual page 27

3
Close door. Locate the two hex screws on the left side
of the door that secures the bearing assembly.
Do not loosen the bearing bolts.
5
If the right side of the door is not resting on the hearth
when the door is fully closed, significantly loosen (but
do not remove) the upper hex screw.
note:
For clarity purposes, some parts of the appliance have been hidden.
7
Insert shims in behind the bearing bracket until the gap
is filled.
9 Reverse instructions in step 2 to reinstall the left side trim.
operation and adjustments
4
If the left side of the door is not resting on the hearth
when the door is fully closed, significantly loosen (but do
not remove) the lower hex screw.
6
Pull the door down fully until it is completely resting flat
on the hearth.
8
Tighten loosened hex screw and verify the door is level.
It may be necessary to add or remove an
additional shim to achieve optimal results. It should
never be necessary to shim both upper and lower
hex screws.
EN
27
W415-1720 / E / 08.23.18