Notice - Sanyo FW32D08F Manual

1 Notice

SANYO is a registered trademark of SANYO Electric Co., Ltd. and is used by
Funai Electric Co., Ltd. and Funai Corporation, Inc. under license from SANYO
Electric Co., Ltd.
Any liability related to SANYO products, including design and quality, is the
sole responsibility of Funai Electric Co., Ltd. and Funai Corporation, Inc.
Please contact Funai Corporation, Inc. for any questions or claims related to
SANYO products: www.sanyo-av.com
Funai Corporation reserves the right to change products at any time without
being obliged to adjust earlier supplies accordingly.
The material in this Owner's manual is believed adequate for the intended
use of the system. If the product or its individual modules or procedures are
used for purposes other than those specified herein, confirmation of their
validity and suitability must be obtained. Funai Corporation warrants that the
material itself does not infringe any United States patents. No further
warranty is expressed or implied.
Funai Corporation cannot be held responsible neither for any errors in the
content of this document nor for any problems as a result of the content in
this document. Errors reported to Funai Corporation will be adapted and
published on the Funai Corporation support website as soon as possible.
Pixel characteristics
This LCD product has a high number of color pixels. Although it has effective
pixels of 99.999% or more, black dots or bright points of light (red, green or
blue) may appear constantly on the screen. This is a structural property of the
display (within common industry standards) and is not a malfunction.
Warranty
No components are user serviceable. Do not open or remove covers to the
inside of the product. Repairs may only be done by service centers and official
repair shops. Failure to do so shall void any warranty, stated or implied.
Any operation expressly prohibited in this Owner's manual, any adjustments
or assembly procedures not recommended or authorized in this Owner's
manual shall void the warranty.
Federal communications commission notice
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna.
●
Increase the separation between the equipment and the receiver.
●
Connect the equipment into an outlet on a circuit different from that to
●
which the receiver is connected.
Consult the dealer or an experienced radio or television technician for help.
●
This device complies with Part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Declaration of conformity
: SANYO
Trade name
: Funai Corporation, Inc.
Responsible party
: FW32D08F
Model
: 12489 Lakeland Road, Santa Fe Springs, CA
Address
90670, USA*
: 1 866 212 0436
Telephone number
* This is not the mailing address for Open Source Software or Customer
service.
Modifications
This apparatus may generate or use radio frequency energy. Changes or
modifications to this apparatus may cause harmful interference.
Any modifications to the apparatus must be approved by Funai Corporation.
The user could lose the authority to operate this apparatus if an unauthorized
change or modification is made.
Cables
Connections to this device must be made with shielded cables with metallic
RFI / EMI connector hoods to maintain compliance with FCC Rules and
regulations.
Canadian notice
CAN ICES-3 (B)/NMB-3 (B)
Analog and digital television receiving apparatus, Canada BETS-7 /
NTMR-7.
Positioning the TV
Large screen TVs are heavy. 2 people are required to carry and handle a
●
large screen TV.
Make sure to hold the upper and bottom frames
●
of the unit firmly as illustrated.
Install the unit in a horizontal and stable position.
●
Do not install the unit in direct sunlight or in a
●
place subject to dust or strong vibration.
Depending on the environment, the
●
temperature of this unit may increase slightly.
This is not a malfunction.
When installing this unit in a temperate environment, avoid a place with
●
rapid temperature changes.
Operating temperature: 41°F (5°C) to 104°F (40°C)
–
This unit should not be used in a tropical environment as it has not been
●
evaluated under such conditions.
No objects should be placed directly on or under this unit, especially lighted
●
candles or other flaming objects.
Depending on your external devices, noise or disturbance of the picture
●
and / or sound may be generated if the unit is placed too close to them. In
this case, please ensure enough space between the external devices and
the unit.
Do not insert the AC power cord into the power socket outlet before all the
●
connections are made.
Ensure that you always have easy access to the AC power cord and outlet
●
to disconnect the TV from the AC outlet.
Before you move the TV, disconnect attached cables to prevent damage
●
to connectors, especially the TV tuner.
Be sure to unplug the AC power plug from the AC outlet before moving
●
or carrying the unit.
When moving the TV and then setting it down, please be careful not to
●
pinch the AC power cord under the unit.
Do not place this unit in an area where it may be exposed to water, oil or
●
grease such as:
near a bathtub, basin, kitchen sink, washing tub, swimming pool, kitchen
exhaust fan, etc., or in a damp basement.
Regulatory notices
WARNING : To prevent injury, this apparatus must be securely attached
to the furniture / wall in accordance with the instructions.
Tipping, shaking or rocking the unit may cause injury / death.
WARNING : Never place a TV in an unstable location. A TV may fall,
causing serious personal injury or death. Many injuries,
particularly to children, can be avoided by taking simple
precautions such as:
Using cabinets or stands recommended by the
–
manufacturer of the TV.
Only using furniture that can safely support the TV.
–
Ensuring the TV is not overhanging the edge of the
–
supporting furniture.
Not placing the TV on tall furniture (for example,
–
cupboards or bookcases) without anchoring both the
furniture and the TV to a suitable support.
Not placing the TV on cloth or other materials that may
–
be located between the TV and supporting furniture.
Educating the children about the dangers of climbing on
–
furniture to reach the TV or its controls.
If your existing TV is being retained and relocated, the same considerations
as above should be applied.
5 .
English