Reverse Door Swing (Optional) - Whirlpool WPWADREW25 Installation Instructions Manual

If you do not feel heat, turn off dryer, and check the
following:
There may be 2 household fuses or circuit breakers for
■
the dryer. Check that both fuses are intact and tight, or
that both circuit breakers have not tripped. If there is still
no heat, contact a qualified technician.
NOTE: You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.

Reverse Door Swing (Optional)

29"
Super Wide Side-Swing Door
1.
Place towel on dryer
Place towel on top of dryer to avoid damaging the surface.
NOTE: Magnetized screw driver is helpful.
2.
Remove bottom screws
Open dryer door. Remove bottom screws from dryer cabinet
side of hinges. Loosen (do not remove) top screws from dryer
cabinet side of hinges.
3.
Lift door off top screws
Lift door until top screws in dryer cabinet are in large part of
hinge slot. Pull door forward off screws. Set door (handle side
up) on top of dryer. Remove top screws from dryer cabinet.
4.
Remove screws from hinges
Remove screws attaching hinges to door.
5.
Remove screws from door
Remove screws at top, bottom, and side of door (4 screws)
that hold the inner and outer door together. Holding door over
towel on dryer, grasp sides of outer door and lift to separate it
from inner door. Set outer door aside.
NOTE: Do not pry apart with putty knife or screwdriver.
Do not pull on door seal or plastic door catches.
17