Download Print this page

Cutout Dimensions; Electrical Requirements - Viking RVEWD Installation Manual

Built-in electric warming drawer

Advertisement

Cutout Dimensions

Indoor
Cutout width (A)
Cutout depth (B) 23-1/2" (59.7 cm)
Cutout height (C)
Flush Mount Option:
Note: To install the warming drawer in a flush mount application, a flush mount
accessory kit is required and sold separately.
C
A
B
Cutout width (A)
Cutout depth (B) 25-1/8" (63.8 cm)
Cutout height (C) 10-1/8" (25.7 cm)
6
RVEWD
28-1/4" (71.8 cm)
9-1/4" (23.5 cm)
RVEWD
29-5/8" (75.3 cm)

Electrical Requirements

Electrical Requirements
Check your national and local codes
regarding this unit. Hard wire direct with
seperate 120V/15 amp minimum 2-wire
wtih ground circuit. Maximum amp usage.
RVEWD
Max. amp
450 watts
usage
3.8 amps
Electrical Connection
Note: Use copper conductors ONLY!
Grounding Instructions
This appliance must be connected to a
grounded metal, permanent wiring system,
or an equipment-grounding conductor
must be run with the circuit conductors and
connected to the equipment-grounding
terminal or lead on the appliance.
With the appliance positioned in front of
the cabinet opening, connect wire leads
extending from the power supply to the
terminal block of the unit. Make sure the
colored wires of the terminal block are
connected to the corresponding colored
wires extending from the power supply.
7
WARNING
ELECTRICAL SHOCK
HAZARD
To avoid the risk of electrical
shock, personal injury or death;
verify electrical power is turned off at the
breaker box until the range is installed
and ready to operate, installation by an
authorized installer only.

Advertisement

loading

This manual is also suitable for:

3 seriesRvewd330ss