Table of Contents
Advertisement
GETTING STARTED
P-touch Labeling System
• Charging current: 800 mA
• Charging voltage: up to 8.2 V (Maximum)
Alkaline/Ni-MH Battery
1
After making sure that the power is off, remove the rear cover
on the back of the P-touch labeling system. If the batteries
are already in the P-touch labeling system, remove them.
Make sure that the power is turned off when replacing
batteries.
2
Insert six new AA-size alkaline batteries (LR6), or fully
charged Ni-MH rechargeable batteries (HR6). Make sure
that the positive (+) and negative (-) ends of the batteries
match the positive (+) and negative (-) marks inside the
battery compartment.
Users of alkaline batteries
23
Always replace all six batteries at the same time using brand
new ones.
Users of Ni-MH rechargeable batteries
Always replace all six batteries at the same time with fully
charged ones.
Visit us at http://solutions.brother.com/ for the latest
information about recommended batteries.
3
Attach the rear cover by inserting the three hooks at the
bottom into the slots on the P-touch labeling system, then
pushing down firmly until it snaps into place.
• Remove the batteries if you do not intend to use the P-touch labeling system for an extended
period of time.
• Dispose of the battery at an appropriate collection point, not in the general waste stream. In
addition, be sure to observe all applicable regulations.
• When storing or discarding the battery, wrap it (for example with
cellophane tape), to prevent it from short-circuiting.
(Battery insulation example)
1. Cellophane tape
2. Alkaline or Ni-MH battery
28
Power Supply
2
1
Advertisement
Table of Contents
