Sub-Zero IT36CILH Use And Care Manual page 8

ST O R A G E
Refrigerator Storage
GL A S S S HE LVE S
To reposition a glass shelf:
To remove, tilt the shelf up, then lift up and out. Refer to
1
the illustration below.
To reinstall, insert the shelf in the tracks along the back
2
wall, then lower the front until it locks into position.
The stationary glass shelf at the bottom of the compartment
should be placed with beveled edge facing front. Rear sup-
port legs space the shelf away from the back wall to ensure
proper air flow through the unit.
Use care when handling glass shelves to
IMPORTANT NOTE:
prevent breakage or scratching the interior.
CAUTION
Glass shelves should warm to room temperature before
immersing in warm water.
Glass shelf removal
|
8 Sub-Zero Customer Care 800.222.7820
R EFR IG ERATO R D RAW ER S
To remove/reinstall a refrigerator drawer:
To remove, pull the drawer open until it stops. Lift the
1
front of the drawer slightly and pull straight out. Refer to
the illustration below.
To reinstall, pull the drawer carrier out and align the
2
bottom of the drawer with the carrier. Slide the drawer
back into position
.
To reposition a refrigerator drawer divider:
To remove, pull the divider straight up.
1
To reinstall, align tabs on the divider with notches in the
2
drawer and push down.
Refrigerator drawer removal Refrigerator drawer removal