Make Gas Connection - Maytag MGT8800FZ Installation Instructions Manual

3. Determine and mark edge of range in the cutout space. The
mounting bracket can be installed on either the left side or
right side of the cutout. Position mounting bracket in cutout
so that right (or left) edge of the bracket is
the marked edge of the range, as shown.
B
A. Anti-tip bracket
B. Mark edge of
range.
C. /
15
4. Drill two / " (3.0 mm) holes that correspond to the bracket
1
8
holes of the determined mounting method. See the following
illustrations.
Floor Mounting
A
B
A. #12 x 1 5 / " screws
8
B. Anti-tip bracket
5. Using a Phillips screwdriver, mount anti-tip bracket to the
wall or floor with the two #12 x 1
8
/ " (2.4 cm) from
15
16
A
C
" (2.4 cm)
16
Wall Mounting
A
A. #12 x 1 5 / " screws
8
B. Anti-tip bracket
/ " screws provided.
5
8

Make Gas Connection

Use a new CSA International approved gas supply line.
Install a shut-off valve.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure
gas pressure does not exceed 14" (36 cm) water
column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and
authorized service personnel.
Failure to do so can result in death, explosion, or fire.
Typical flexible connection
1. Apply pipe-joint compound made for use with LP gas to the
smaller thread ends of the flexible connector adapters (see B
and G in the following illustration).
2. Attach one adapter to the gas pressure regulator and
B
the other adapter to the gas shut-off valve. Tighten both
adapters.
3. Use a / " combination wrench and an adjustable wrench to
15
16
attach the flexible connector to the adapters. Check that
connector is not kinked.
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have
/ " male pipe thread)
1
2
D. Flexible connector
WARNING
Explosion Hazard
A
B
C
D
H
G
E
F
E. Manual gas shut-off valve
F. / " or / " gas pipe
1 3
2 4
G. Use pipe-joint compound.
H. Adapter