Installation&Setup - Samsung RL26DCAS Instruction Manual

TROUBLE SHOOTING
12
The appliance does not work.
- The Plug is not well connected.
- No power supply.
- Resart the appliance within 5 minutes
after power-off.
Nonstop working is incurred to the appliance.
- When the room temperature is high, or the
appliance is near heat or exposed in the sun.
- The door is opened frequently or well closed.
- The room has poor ventilation.
- The food is over stuffed, resulting in bad cooling.
The food in the refrigerator is frozen
- The thermostat setting is too low.
- The foods contact the cooling source
in the back wall.
Noise is heard
- The appliance is not steadily placed.
- The appliance is too close to the wall.
- The exterior cooling pipes clash with
each other or with fridge wall.
- Something unexpected is behind or under.
- The motor will give out buzz when running.
- Items stored are not steadily placed.
The freezer generates poor effect.
- The door is not well closed.
- The door gasket is damaged or distored or
poorly sealed.
- The appliance is near heat or exposed in
Sun.
- The appliance is not well aired.
The defrost water outflows inside.
- The water outlet is block.
- Please get rid of the block with a
plug or similar tools.
Change the lamp
Pull out the power plug.
Remove the screws from the lamp cover, then hold the rear
with fingers to draw out the cover with forward force.
Turn off the bulb counterclockwise.
Turn on the bulb clockwise.
Hang the back hook first, fix the front hook and fit the screws.
Lamp parameters: ~220V-240V,25W E14
INSTALLATION & SETUP
Place the refrigerator
1.Remove the foot cushion prior to use.
2.If the appliance is placed unsteadily, you may adjust the front leg in the bottom to stablize
the appliance (lift by turning left).There is a adjust hole in the front leg.You may adjust it
with a crosshead screwdriver (see right figure).
3.The ground under the appliance shall be flat and solid.
Otherwise noise and oscillation will arise.
The noise will grow stronger if the
appliance is put on the soft ground;
Please put a solid plate on the blanket,
to avoid miscolor or heat blocking;
To stablize the appliance, please leave
the foot contacting the ground closely and
keep the appliance leaning back for easy closing of the door.;
Packaging & handling
1.Unpacking, repacking and handling
Do remember where the packages are during unpacking and examining.
The products can not be transported until they are repacked after examining.
2.Do not hold the door during transportation.
3.Avoid clash or acute shaking during handling.
4.Vertical handling to avoid clash
Do not position the appliance reversely or horizontally.
If tilting is required, the tilting angle shall be less than45
Please handle the appliance as per the instructions to
prevent from noise or some other problems.
45
5