Table of Contents
Advertisement
Product support
Help is always at hand
FAILURE
Too much detergent has been used.
Excessive foam
in the detergent
drawer.
Wrong detergent has been used.
Your laundry is too dirty for the
programme you have selected.
The washing result
is poor.
The amount of detergent used is not
sufficient.
Clothes exceeding the maximum
capacity have been loaded in the
machine.
The washing result
Your water may be hard.
is not good.
Distribution of the clothes in your
machine is not well-balanced.
The water is drained
The end of the water drain hose is in
from the machine as
a position too low according to the
soon as it is filled.
machine.
No water is seen
No failure. The water is in the lower part
in the drum during
of the drum.
washing.
Some detergents contain ingredients
There are residues
which are not soluble in water and
of detergent on the
which may form white stains on your
clothes.
clothes.
These stains may be caused by oil,
There are grey stains
cream or ointment.
on the clothes.
No failure. The unbalanced load control
may work in that way.
The spinning
process is not done
or starts with delay .
(*) See the section concerning the care and maintenance of your machine.
(**) See the section concerning installation of your machine.
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.newworldassist.co.uk If you still require further assistance, call one of our experts on 0333 305 2263.
PROBABLE CAUSE
METHODS OF ELIMINATION
Press the start/pause button.In order to
stop the foam, dilute one table-spoon of
softener in half liter of water and pour it in the
detergent drawer. Press the start/pause button
after 5-10 minutes. Arrange the amount of
the detergent properly in the next washing
process.
Use only the detergents produced for full
automatic machines.
Select a suitable programme.
Use more detergent.
Put the clothes in your machine in a manner
not to exceed its maximum capacity.
Use the amount of detergent specified by the
detergent manufacturer.
Spread the clothes inside the machine in an
orderly and well-balanced manner.
Position the water drain at an appropriate
height. (**)
-
By adjusting your machine, carry out an
additional rinse, or eliminate the stains after
drying, with a brush.
In the next washing operation, use the
maximum detergent amount declared by the
detergent producer.
The unbalanced load control system will try
to distribute your clothes in a homogenous
manner. After your clothes are distributed,
passage to spining process will be realized. In
the next washing process, place your clothes
into the machine in a well-balanced manner.
Product support
35
Advertisement
Table of Contents
