Connections
Connections
When the TV is initially powered on, basic settings proceed automatically.
✎
Preset: Connecting the mains and antenna.
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings. Press the
POWERP button. Plug & Play is available only when the Input Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected.
✎
To return to the previous step, press the Red button.
1
Selecting a language
2
Selecting Store Demo
or Home Use
3
Selecting a country
4
Setting the
Clock Mode
5
Selecting an antenna
6
Selecting a channel
7
Enjoy your TV.
If You Want to Reset This Feature...
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0"
(France: "1-1-1-1"). If you want to change the PIN number, use the Change PIN function.
You should do Plug & Play
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which resets
the PIN to "0-0-0-0"(France: "1-1-1-1"):
Connecting to an Antenna
Plug & Play (Initial Setup)
Press the ▲ or ▼ button, then press the ENTERE button.
Select the desired OSD (On Screen Display) language.
Press the ◄ or ► button, then press the ENTERE button.
y Select the Home Use mode. Store Demo Mode is for retail
environments.
y To return the unit's settings from Store Demo to Home Use
(standard): Press the volume button on the TV. When you see the
volume OSD, press and hold
y Store Demo is only for shop display. If you select it, several
functions are not able to use. Please select Home Use when you
watch at home.
Press the u or d button, then press the ENTERE button. Select the appropriate
country.
✎
After selecting the country in the Country menu, some models may proceed with an
additional option to setup the pin number. When you input the PIN number, "0-0-0-0"
is not available.
Set the Clock Mode automatically or manually.
Press the ▲ or ▼ button, then press the ENTERE button.
Select the Antenna source to memorise.
Press the ▲ or ▼ button, then press the ENTERE button.
Select the channel source to memorise. When setting the antenna source to Cable, a step
appears allowing you to assign numerical values (channel frequencies) to the channels. For
more information, refer to Channel → Auto Tuning (p. 24).
Press the ENTERE button.
→ System) again at home although you did in shop.
(MENU
(off) →
POWER
MENU
for 5 sec.
→ 8 → 2 → 4 →
MUTE
POWER
ANT OUT
POWER
P
(on).
15
English