Necessary Settings before Use
MENU
Set Lever
Be sure to confi gure the following three
settings before use.
Charging the Battery Pack
1
Set the power/mode switch to OFF.
Slide while pressing down the lock button.
Required charging / recording time
(approx.)
The values within ( ) are the times when the
LED light is on.
Battery pack Charging time
BN-VF808U
(Provided)
BN-VF815U
BN-VF823U
12
Access/Charge
Lamp
Power/Mode
Switch
MODE
ON
OFF (CHARGE)
Recording
1 hr. 35 min.
1 hr. 30 min.
(1 hr. 30 min.)
3 hr. 15 min.
2 hr. 40 min.
(3 hr. 5 min.)
4 hr. 55 min.
3 hr. 50 min.
(4 hr. 35 min.)
2
Attach the battery pack.
Slide the battery pack down until it locks in place.
Bottom of the Camera
3
Connect the AC adapter.
* If the provided AC adapter is AP-V14E,
connect the power cord to the AC adapter,
and plug the power cord into an AC outlet.
•
The access/charge lamp blinks to indicate
charging has started.
•
When the lamp goes out, charging is
fi nished. Unplug the AC adapter (or
the power cord) from the AC outlet and
disconnect the AC adapter from the camera.
8 To detach the battery pack
Slide and hold BATT. (
remove the battery pack.
8 To check the remaining battery power
See page 14.
time
NOTES
•
You can also use the camera with just the AC
adapter.
•
Please do not pull or bend the AC adapter plug
and cable. This may damage the AC adapter.
DC Connector
Open the cover.
BATT.
To AC Outlet
(110V to 240V)
AC Adapter
(ex. AP-V17E)*
step 2), then